Stainless steel is the metal people trust in places that work hard: a restaurant service line, a hotel bar, a shop counter, a clinic reception. It takes daily cleaning, keeps its color and looks right next to stone, wood and glass. It is also unforgiving: every scratch and mismatch in the grain shows, so it needs careful handling from the first cut.
We fabricate stainless parts for designers, fixture and millwork shops, kitchen fit-out teams and equipment builders. Sheets keep their protective film through cutting and forming, brushed grain runs the same way across a set, and edges are finished so they are comfortable to touch.
What we make
Counter and bar cladding
Brushed or polished face panels, edge caps and toe kicks for counters and bars.
Kick and push panels
Plain or perforated panels for doors, cabinet fronts and service areas.
Trims and corner guards
Edge trims, corner guards and reveals for walls and fixtures that take knocks.
Fixture parts
Shelves, brackets, covers and small enclosures for shop and restaurant fixtures.
Brushed, polished or bead look
Most interior stainless is brushed: fine straight lines that hide small marks and light scratches. Polished stainless is a mirror and suits small accents more than large flat panels, where it shows every ripple. A soft satin finish sits in between. We make a small finish sample for approval, and we keep the brushing direction consistent so neighbouring panels read as one surface.
Keeping stainless clean in the shop
Stainless needs to stay away from plain steel dust to keep its look. We handle it with clean tools, separate abrasives and covered benches, and keep the film on until the parts are packed. Ground edges are brushed back to match the face. Each part goes into the crate wrapped and labeled.
When a piece combines stainless with another material, such as a steel frame behind a stainless face, we talk through how the two meet before we quote, so the visible side stays clean.
Stainless steel fabrication: common questions
Which stainless do you use?
For interiors we usually work with a common general purpose stainless sheet. If your specification names a different one, tell us and we check availability.
Can you match an existing brushed finish?
Usually. A small offcut or sample piece helps a lot. We make a sample for your approval before the full set.
Is polished stainless a good idea for large panels?
It can look striking, but large mirror panels show every ripple and fingerprint. We often suggest brushed or satin for large faces and polished for small accents.
How should stainless be cleaned?
Warm water, a mild soap and a soft cloth, wiped along the grain. Avoid steel wool and scouring pads, which leave marks and can stain the surface.
Do you make stainless parts for kitchens?
We make fixture parts such as cladding, shelves, covers and trims for commercial kitchen and bar areas, built to your drawings.
Cookies. We use necessary cookies so pages and forms work. With your OK, we may also use analytics and advertising cookies. Your choice is remembered for 6 months. Cookie Policy
Manage Cookies
Here you decide which optional cookies may run. Your setting is saved for 180 days. Browsers that send a Global Privacy Control signal are treated as having rejected optional cookies.
Strictly necessaryAlways on
Keep the site working and secure and remember your cookie choice.
Show which pages people read, so we can improve them. Off by default.
Measure whether an ad led to a quote request. Off unless you turn it on.
Because your browser sends a Global Privacy Control signal, optional cookies are kept off.