Bending is how a flat sheet gets its strength and its line. A simple return along one edge stops a panel from flexing. Two folds make a channel; three or four make a cap or a box section. In architectural work most of what people see on a trim is the result of a few careful bends.
We form sheet metal on the press brake for designers, millwork and fixture shops, sign makers and equipment builders. Bends are planned from the inside out: the section you need, the material and thickness, the order of folds and the tooling that will leave the visible face clean.
What we make
Trims and flashings for interiors
Edge trims, shadow gap profiles and corner pieces for walls, counters and displays.
Angles and channels
Simple folded sections used as frames, stiffeners and supports for panels and fixtures.
Caps and covers
Folded caps for counters, ledges and partitions, and covers for equipment and services inside a cabinet.
Panel returns
Folded edges that hide a panel's thickness and keep it flat.
Drawing a section we can bend
A section drawing with dimensions to the outside or inside of each leg, the angle of each fold and the length of the piece is all we need. Mark which face is visible. If the profile has a very short leg, a tight return or a hem, we check it against our tooling and suggest a small change if a bend would mark the face or not form cleanly.
Holes and cut-outs near a bend can stretch when the sheet is formed. We place them in the flat pattern so they come out where your drawing shows them.
Long runs and consistent angles
Trim for a whole lobby needs every piece to match. We set up once, form a first piece for checking against your section, then run the batch. Long pieces are handled with support so they stay straight, and protective film stays on brushed and polished faces until the parts are packed.
Metal bending services: common questions
Can you bend sheet that I supply?
Often, yes, if it is clean, flat and suits our tooling. Tell us the material and thickness and we confirm before you bring it in.
How long can a bent piece be?
Our press brake handles interior trim lengths comfortably. If your run is longer, we suggest a joint position that looks intentional.
Will the bend mark a brushed or polished face?
We keep protective film on visible faces and choose tooling to avoid marks. Tell us which face is visible and we plan around it.
Can you bend stainless and aluminum?
Yes. Each behaves a little differently, so we adjust the bend allowance and tooling for the material you choose.
Do you also cut the flat blanks?
Yes. Most bent parts start on our laser table, so holes, notches and outline come out accurate before forming.
Cookies. We use necessary cookies so pages and forms work. With your OK, we may also use analytics and advertising cookies. Your choice is remembered for 6 months. Cookie Policy
Manage Cookies
Here you decide which optional cookies may run. Your setting is saved for 180 days. Browsers that send a Global Privacy Control signal are treated as having rejected optional cookies.
Strictly necessaryAlways on
Keep the site working and secure and remember your cookie choice.
Show which pages people read, so we can improve them. Off by default.
Measure whether an ad led to a quote request. Off unless you turn it on.
Because your browser sends a Global Privacy Control signal, optional cookies are kept off.